What makes our used outboards so special

We get asked all the time what makes our used engines special. The honest answer is that nothing clever happens. We just don’t skip steps. I filmed the process on a 115 Yamaha so you can see it, and the video is below.

This article is about our fixed-price used outboards, the ones listed on the website at a price you can pay today. Every one that leaves fully serviced comes with our 6 months parts and labour warranty.

What gets done

On the bench, a used engine gets the lot. Engine oil. Thermostat. The anodes under the powerhead and every external anode. The impeller. Fuel filter and oil filter, and the fuel system cleaned out. All the oils and lubes, and a grease gun on every grease point. The gearbox is serviced, the power trim and tilt oil is topped up, and the midsection and shock mounts are checked. The prop gets checked too. Sometimes it’s new, sometimes it’s a good used one, but it’s always sized and fitted to suit the boat it’s going on.

Two tests matter more than the rest. The compression is tested on every cylinder, and the gearbox backlash is checked. Then comes the one I care about most: a full tank test, 30 minutes under full load at varying revs. Forward, reverse, tilt up, tilt down, stop on the key, stop on the kill switch.

Why the tank test is the one that counts

Anyone can start an engine on a hose for two minutes and call it running. A cold engine on a hose tells you very little. Half an hour under load is long enough for a tired engine to show itself: it runs warm, it hunts, it won’t hold its revs, it stalls when you drop it into gear. Most of what’s wrong with a used engine only appears when it has been working for a while, so that’s when we make it work.

The kill switch test is there for a reason too. If your kill cord doesn’t stop the engine, nothing else about it matters.

What you’d want in the box

A used engine is no use if it arrives and you then discover you need cables. On our used engines we supply battery cables, control cables and the control box with it. In the video the customer asked for a gauge, which isn’t always included but is always available. Check the listing for what comes with each engine.

Getting it to you in one piece

The bit people never see is the packing. We take the gearbox off, put foam or cardboard underneath, and tie it down so it can’t move. The controls go on top of the gearbox, wrapped carefully, not too tight. Then pallet wrap, a bit of tape and the shipping label. I either love or hate that part of the job depending on how the wrap goes. An engine that was perfect on the bench and arrives scratched is still a bad sale.

A different thing: auction lots

Our website auction lots are not all like this. Some are serviced, some are sold as seen, and each lot page says which. I’ve written that up separately: https://www.billhigham.co.uk/bill-higham-marine-auctions-how-they-work/

What to do next

If you’re after a used outboard, have a look at what’s in stock on the website: https://www.billhigham.co.uk/category-main/used-outboards/. Not sure which shaft length or horsepower you need? Ask us before you buy, and we’ll tell you if we haven’t got the right one.

Think I missed a step? Got your own tale of a used engine that wasn’t what it seemed? Let’s hear it in the comments.

Social Share

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.